ham radio deluxe waterfall not full width

But the higher rates don’t work – 19200 is still the maximum. There seems to be a bug in the V1.20 IC-7300 firmware that can still show higher baud rates even when “ Link to ” is select. When “ Link to ” is selected, the CI-V USB Baud Rate will max out at 19200. This is because those settings require setting the CV-I USB Port setting to “ Link to ” which imposes the 19200 baud limit. If you use the WSJT-X native IC-7300 settings, 19200 is the maximum baud rate you can select. To use this effectively, this means running the serial port at 115200 baud. One the big advantages of using DXLab Commander is its ability to show the IC-7300 waterfall spectrum display on you computer monitor. You can even setup DXLab Launcher to do this automatically. Then run Commander first, followed by WSJT-X. Setup WSJT-X to use DXLab Commander CV-I Driver You cannot use both the native IC-7300 setup for WSJT-X and Commander at the same time.įortunately, you can still use both at the same time by selecting the DXLab Suite as the radio selection from the WSJT-X Config screen. If you use both WSJT-X and DXLab Suite Commander, you will find that both of these programs need to use the serial CI-V interface to your IC-7300.

Ham radio deluxe waterfall not full width